我的仿真参数设置从零开始 到0.02结束 但一仿真就先从1到10 然后才从0到0.02 为什么
Warning: Using a default value of 0.0004 for maximum step size. The simulation step size will be equal to or less than this value. You can disable this diagnostic by setting 'Automatic solver parameter selection' diagnostic to 'none' in the Diagnostics page of the configuration parameters dialog.
warning:The specified buffer for 'sanxiangzhengliu/Transport Delay' was too small. During simulation, the buffer size was temporarily increased to 263168. In order to use Real-Time Workshop, you need to update the buffer size parameter.
发表于 2009-3-18 12:14
提升卡
变色卡
显身卡
楼主