声振论坛

 找回密码
 我要加入

QQ登录

只需一步,快速开始

查看: 1478|回复: 1

battery discharge注意事项

[复制链接]
发表于 2017-8-9 08:21 | 显示全部楼层 |阅读模式

马上注册,结交更多好友,享用更多功能,让你轻松玩转社区。

您需要 登录 才可以下载或查看,没有账号?我要加入

x
本帖最后由 andyzour 于 2017-8-9 08:22 编辑

各位大神:
有没有用过CSI2130 battery discharge这个功能键?能介绍一下使用时的注意事项吗?谢谢!
回复
分享到:

使用道具 举报

 楼主| 发表于 2017-8-10 08:00 | 显示全部楼层
刚刚找到注意事项,和大家一起分享一下。
Battery Discharge (CSI 2130 with Ethernet port and SD slot only)
When the external power supply/charger is plugged into the CSI 2130 the battery
charge circuit has the ability to control a battery discharge. Discharging
the pack allows the gas gauge circuitry to be calibrated. During the discharge
cycle the charge circuit monitors the voltage of the battery pack and terminates
the discharge once the pack is discharged. Once the pack is discharged,
the charging circuit automatically stops the discharge and starts charging in
fast mode.
The gas gauge circuitry exists to provide information about the status of the
analyzer’s battery pack. The primary purpose is to report the amount of
charge remaining in the battery pack. Additional information includes how
many times the pack has been charged since it was calibrated, how much
charge was available after the last “Last Measured Discharge” (a calibration
cycle), and other status information. The Gas Gauge IC also has an
“EMPTY” output pin that is wired to the analyzer.
Discharging the battery is not a trivial task. The amount of time require to discharge
and recharge the analyzer will vary between 16-30 hours depending
on the initial charge level of the battery, the condition of the battery, and the
hardware revision of the CSI 2130. Therefore, initiate the discharge when you
have enough time to do so, such as over night or over the weekend.
您需要登录后才可以回帖 登录 | 我要加入

本版积分规则

QQ|小黑屋|Archiver|手机版|联系我们|声振论坛

GMT+8, 2024-3-29 13:22 , Processed in 0.067283 second(s), 17 queries , Gzip On.

Powered by Discuz! X3.4

Copyright © 2001-2021, Tencent Cloud.

快速回复 返回顶部 返回列表