我想建立一个简单的轧制钢板的模型,轧辊选用1/4的解析刚性体,并用两个轧辊.
结果运行失败,出现以下错误:
The elements contained in element set ErrElemExcessDistortion-Step1 have distorted excessively.
Print-out suppressed for subsequent distorted elements
There are a total of 25 excessively distorted elements
The ratio of deformation speed to wave speed exceeds 1.0000 in at least one element. This usually indicates an error with the model definition. Additional diagnostic information may be found in the message file.
The elements contained in element set ErrElemExcessDistortion-Step1 have distorted excessively.
ABAQUS/Explicit Analysis exited with an error - Please see the status file for possible error messages if the file exists.